ITEM 項目
|
TEST CONDITIONS 測試條件
|
PERFORMANCE 規(guī)格
|
4.1
|
CONTACT
RESISTANCE
接觸電阻
|
MEASURED AT 1KHz SMALL CURRENT(100mA OR LESS)
在1KHz微小電流(100mA以下)測試.
|
100mΩMAX.
100毫歐以下
|
4.2
|
INSULATION
RESISTANCE
絕緣電阻
|
APPLY A VOLTAGE OF 500V DC FOR 1 MIN.
TO FOLLOWING PORTIONS AFTER WHICH
MEASUREMENT SHALL BE MADE.
(1)BETWEEN BODY AND TERMINAL。
(2)BETWEEN TERMINALS。
輸入500V DC 電壓1分鐘,按以下接觸方法測試:
(1)排腳相互之間。
(2)排腳與外殼之間。
|
100MΩMIN.
100兆歐以上.
|
4.3
|
DIELECTRIC
STRENGTH
耐電壓
|
AC 500V rms(50-60Hz)FOR 1 MIN TRIP
CURRENT:0.5mA
(1)BETWEEN TERMINALS.
(2)BETWEEN INDIVIDUAL TERMINAL AND FRAME.
輸入AC 500V(50-60Hz)電壓,1分鐘感度電流為0.5mA,
按以下接觸方法測試:
(1)排腳相互之間
(2)排腳與外殼之間.
|
WITHOUT DAMAGETOPARTS
ARCING OR BREAKDOWN ETC
沒有絕緣破壞等異常
|
5、MECHANICAL CHARACTERISTICS (機械性能規(guī)格)
|
ITEM 項目
|
TEST CONDITIONS 測試條件
|
PERFORMANCE 規(guī)格
|
5.1
|
OPERATING
FORCE
作動力
|
MEASUREMENT SHALL BE MADE AT THE
NEAREST POINT OF THE COMPONENTOR
AT THE POINT 3mm FROM THE TIP OF THE
ACTUATOR(KNOB).
在距離膠柄前端3mm作測定點.
|
300gf±100gf
|
5.2
|
TERMINAL
STRENGTH
端子強度
|
A STATIC LOAD OF(500gf)SHALL BE APPLIED
TO THE TERMINAL FOR 15 SEC,IN ANY DIRECTON.
在排腳前端任意一個方向加500gf力度測試,時間為15秒.
|
MECHANICAL AND
ELECTRICAL
CHARACTERISTICS SHALL
BE SATISFIED WITHOUT
LOOSENESS OF ACTUATOU.
在端子中沒有裂開,松動等異常,
滿足于機械、電器性能。
|
5.3
|
DISPLACEMENT
OF ACTUATOR
(KNOB)
柄 強 度
|
A STATIC LOAD OF 10N(1Kgf)SHALL BE APPLIED
TO THE TOP OF THE ACTUATOR(KNOB)AND THEN
DESPLACEMENT SHALL BE MEASURED TO THE
DIRECTION OF THE ARROW.
在柄的前端施加1Kgf的力度,位移應(yīng)沿印記的方向上定.
|
THE LEVER SHALL HAVE
NO SERIOUS DEFORMATION
AND FUNCTION IS
NORMALLY.
柄部無嚴重變形,可以正常工作.
|